1993-1997 LT1 F-Body Spark Plug Wires

Want to route your plug wires over your valve covers? Here's everything you should need!

• Taylor 8mm Universal Wire kit w/ 90 deg boots (Your choice of red, blue, or black)
• Taylor Opti-Spark End Terminal Kit
• Center-Bolt valve cover wire looms Your choice of two styles!
• Pro-Criming Tool (Your choice of styles: 04-43390 or 04-43395)



The top-mount looms will mount the plug wires to the tops of the valve covers. The side-mount looms will run the wires along side of the valve covers. Thunder Racing only offers our complete kit with the wires and looms in matching colors. (If you order red wires, you will receive red looms, etc.) The brackets on the side mount kit are aluminum and the separators will be the same color as the plug wires.

Thunder Racing now carries Magnecor 8.5mm EMI supressed spark plug wires. Both Magnecor KV85 Competition (8.5mm) and R-100 Racing (10mm) Ignition Cables, are used extensively throughout the world by leading racers and performance minded street vehicle owners to maximize the efficiency of their vehicle's ignition system. Magnecor Race Wires are the only ignition wires that can carry the full output of racing ignition systems while providing superior EMI suppression for electronically managed engines and superior heat resistance.

The MSD 8.5mm Super Conductor Wire is "the" performance wire.  Engineered from the inside out, the 8.5 offers everything you have everwanted in a wire; incredibly low resistance without electronic interference! In a single 12 inch length of Super Conductor Wire there is only 40 - 50 ohms of resistance! That is the lowest resistance of any helically wound wire.

Taylor's 8mm Spiro-Pro wire sets are an excellent replacement wire for both Racing and Street Applications.  These wire sets are pre-made to fit your specific application and are terminated on both ends with the correct ignition and spark plug boots.  They provide maximum firepower without radio interference with up to ten times the conductivity of standard resistor wire.  These are a must for electronic ignition systems and use with computers.  8 mm wires fit both 7 mm and 8 mm applications.

Taylor's 8mm Spiro-Pro wire sets are an excellent replacement wire for both Racing and Street Applications.  Taylor's Cut-to-fit wire sets do not have the ignition boots installed, allowing you to cut the wires to the correct length of your application for a perfect fit.  This works great for custom applications, such as cars with headers.  Taylor Spiro-Pro wires provide maximum firepower without radio interference with up to ten times the conductivity of standard resistor wire.  These are a must for electronic ignition systems and use with computers.  8 mm wires fit both 7 mm and 8 mm applications.  LT1 and LS1 applications require opti-spark end terminal kit, part number 04-46052.  

The Ultimate Performance Wire features a ferrite spiral wound coated core blended of an exclusive copper/nickel allow bonded by a conductive acrylic latex cover. This exclusive process is designed to reinforce the tensile properties of the core and to assist in holding the core resistance to 50 ohms per foot (+/- 20%) under most racing conditions. The Ultimate Performance Wire with only 50 Ohms of resistance per foot!

• 10.4 mm wire = .409 inch diameter
• Three layers of pure ZIMPLEX Silicone
• 600 degree heat protection
• No additional Sleeving Required
• Tightly woven, heat treated fiberglass braid
• Pure silicone "Pro Boot" bonded to wire