2005-2010 Corvette Wiring Harnesses & Solutions

These wiring harnesses allow aftermarket air-fuel gauges to be added to your current front oxygen sensor signal, with complete plug-in capability. Signal wire exits the plug-in assembly and allows addition of wire to your gauge.

Casper's IAT breakout harnesses allows the use of an external, relocated IAT sensor. Relocating the IAT sensor to a location with more accurate ambient temperatures helps prevent the computer from unnecessarily pulling timing which can rob horsepower.  Uses OEM and custom made connectors for a sealed plug-and-play and OEM fit and finish.

Designed to prolong the life of your turbocharger and/or oil. The Innovate Motorsports Auto Timer will allow a vehicle to idle the engine for a timed period, with the ignition key removed. This conveniently allows the engine oil and turbo center cartridge to cool down properly and prolong turbo and oil life. This can be done by two programmable count down presets, or you can use its three auto timer modes (Low-Normal-High). A Manual Timer, Volt-Meter, and *Wideband Air/Fuel Ratio Display are also standard features. Using the Auto Timer to display your Wideband Air/Fuel Ratio requires one of the following Innovate Motorsports wideband controllers: LC-1, LM-1, or LM-2 (*Not included in base Auto Timer kit, P/N: 3830). The Auto Timer Air/Fuel Ratio display range is 7.4 to 22.4, with a 0-5 volt linear input. The safety option for the parking brake can be used to disengage operation if vehicle is attempted to be moved without the key.

These harnesses allows the oxygen sensors to be relocated up to 24 inches from their factory locations. This harness is perfect for the installation of headers which require the sensor be moved further downstream. The high-temperature rated Teflon wire and fiberglass loom allow the harness to be placed close to the exhaust manifolds without worry of being damaged. The harness' small 1/4" outer diameter allows it to be routed in tight areas while providing increased clearance from hot or moving components (i.e. turbo systems). The loom's black outer jacket provides for a low-key appearance in your engine compartment.

KEY FEATURES:

- Fully Plug and Play with the factory harness & sensors
- Avaiable with Military spec. high-temperature Teflon wire (same type used on oxygen sensors)
- Optional High-temperature (1200F) heat-treated black fiberglass 1/4" protective loom (less bulk and superior to plastic loom)
- All connections crimped and soldered