Diesel Truck Shop Use

Maxfilm® is a high film strength, multipurpose, synthetic lubricant / penetrant that excels in a wide array of applications.   Maxfilm® deeply penetrates, cleans and loosens rusted parts. Once applied, its solvent carrier evaporates and leaves a tenacious, thixotrophic lubricating film on all metal surfaces, which provides long-lasting protection against wear, rust and corrosion.

Maxfilm® is Recommended For:

•	Loosening stuck parts such as nuts, bolts, locks, hinges, etc.
•	Lubrication of power tools, hinges, chains, rollers, open gears, guns, fishing tackle, lawn equipment, etc.
•	Preserving and protecting parts in storage, disassembled machinery parts, wire ropes, etc., against rust and corrosion.
•	Use as a manual cutting fluid to facilitate the ease of hand drilling, tapping, metal cutting, etc., of both steel and aluminum.

Air Tool Oil is an excellent lubricant for rotary and piston-type pneumatic tools and hammers. Regular use helps prevent wear and rust while keeping the equipment clean and operating efficiently.

Way 2EZ polish restores new luster to any metal as it adds weather resistant protection.  Makes any metal look brand new again!  Aluminum rims, diamondplate tool boxes, and runningboards will come back to life with Way 2EZ Polish.  Great for chrome, too.  Easy to apply and remove.  Removes tar, rust, oxidation, brake dust, water spots, etc.

Way 2EZ polish is the exclusive polish used by Thunder Racing employees in the shop and on their personal vehicles.  Yes, it is that good.

Red Line CV-2 Grease is designed to withstand the extreme temperatures and pressures which occur in high-performance wheel bearings and CV-joints. The excellent high-temperature stability, extreme- pressure protection, and water resistance enables it to out-perform even the best conventional or synthetic greases. Red Line CV-2 Grease can be used in a wide range of applications at temperatures ranging between -100°F to 500°F and provides good oxidation and corrosion resistance, low evaporation and oil separation, and has a minimum effect on rubber seals. Possesses a very high melting point, excellent water washout resistance and superior antiwear which makes it excellent for high temperatures and extreme loads. CV-2 contains an organic moly and is for wheel bearings, high angle and conventional CV joints, chassis lubrication and high temperature, high speed industrial equipment. The exceptional extreme- pressure performance and the fluidity of the synthetic oil allows increases in bearing life of 200% to 800%. Red Line CV-2 Grease will retain its consistency and extreme-pressure performance under high- temperature and high-shear conditions for extended periods, which extends the performance ranges of the lubricated components. Red Line CV-2 will darken after high-temperature use; this darkening will not detrimentally effect the performance of the grease. Although Red Line CV-2 is compatible with small amounts of many petroleum-based greases, it is always good lubrication practice to thoroughly clean out the old grease to eliminate abrasive particles and to minimize the possibility of grease incompatibility.